Table of Contents
Advertisement
■ Terminals
D
Audio output terminal
C
Audio input terminal
External I/O terminal plug
F
ARJ45 Network terminal
Connect an Ethernet cable (category 5e or better, straight) to the network terminal.
IMPORTANT:
Use all 4 pairs (8 pins) of the Ethernet cable.
The maximum cable length is 100 m {328 feet}.
Make sure that the PoE device in use is compliant with IEEE802.3af standard.
When connecting both the 12 V DC power supply and the PoE device for power supply, 12 V
DC will be used for power supply.
When the Ethernet cable is disconnected once, reconnect the cable after around 2 seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE device.
B
Power supply terminal (12 V DC)
Caution:
A READILY ACCESSIBLE DISCONNECT DEVICE SHALL BE INCORPORATED TO THE
EQUIPMENT POWERED BY 12 V DC POWER SUPPLY.
ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223) or LIMITED
POWER SOURCE (IEC/EN/UL/CSA 60950-1).
Connect the output cable of the DC power supply to the power cord plug (accessory).
RJ45 Network terminal
A
E
EXT I/O terminals
MONITOR OUT terminal
(factory shipment: NTSC monitor)
B
Power supply terminal (12 V DC)
16
Power cord
plug
Advertisement
Table of Contents
