Warnings - Graco ProBell 24Z221 Instructions And Parts

Warnings

Warnings Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific
risks. When these symbols appear in the body of this manual, refer back to these Warnings. Product-specific
hazard symbols and warnings not covered in this section may appear throughout the body of this manual
where applicable.
FIRE AND AND EXPLOSION
FIRE FIRE AND
Flammable fumes, such as solvent and paint fumes, in the work area can ignite or explode.
Paint or solvent flowing through the system can cause static sparking. To help prevent fire or
explosion:
• Electrostatic equipment must be used only by trained, qualified personnel who understand
the requirements of this manual.
• Ground all equipment, personnel, object being sprayed, and conductive objects in or close to
the spray location. Resistance must not exceed 1 megohm. See Grounding
• Do not use pail liners unless they are conductive and grounded.
• Always use the required arc detection settings and maintain a safe distance of at least 6
inches (152 mm) between the applicator and the workpiece.
• Stop Stop operation Stop operation immediately operation
use equipment until you identify and correct the problem.
• Check applicator resistance and electrical grounding daily.
• Use and clean equipment only in a well ventilated location.
• Always turn off and discharge the electrostatics when flushing, cleaning or servicing
equipment.
• Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and
plastic drop cloths (potential static arc).
• Do not plug or unplug power cords or turn lights on or off when flammable fumes are present.
• Keep the spray area clean at all times. Use non-sparking tools to clean residue from the
booth and hangers.
• Keep a working fire extinguisher in the work location.
• Interlock the gun air and fluid supply to prevent operation unless ventilation air flow is above
the minimum required value.
• Interlock the Electrostatic Controller and fluid supply with the booth ventilation system to
disable operation if the air flow falls below minimum values. Follow your local codes.
ELECTRIC ELECTRIC ELECTRIC SHOCK
This equipment must be grounded. Improper grounding, setup, or usage of the system can
cause electric shock.
• Turn off and disconnect power at main switch before disconnecting any cables and before
servicing or installing equipment.
• Connect only to grounded power source.
• All electrical wiring must be done by a qualified electrician and comply with all local codes
and regulations.
3A3954D
WARNING
WARNING WARNING
EXPLOSION HAZARD HAZARD
EXPLOSION HAZARD
immediately if static sparking or repeated arc detection errors occur. Do not immediately
SHOCK HAZARD SHOCK HAZARD HAZARD
Warnings
Grounding instructions. Grounding
3