Paper; Ink Cartridge; The Printer Software Installed With Windows; The Paper And Power Lights Are Flashing - Epson Stylus Color 600Q User Manual

The paper and power lights are flashing
Possible cause
A carriage error has occurred.

All the lights are flashing

Possible cause
You haven't removed all the
packing material from the
printer.
An internal error may have
occurred.
The printer has finished charging the ink cartridge, but the
Possible cause
The ink cartridge clamp isn't
locked down.
Packing material remains in
the printer.
The printer needs to initialize.
The printer software installed with Windows 3.1 does not work correctly after you upgrade to
Windows 95
Possible cause
Your printer software is not
set up correctly for Windows
95.
After you install your printing software, you see the Windows 95 New Hardware Found window
Possible cause
An operating system error has
occurred.
Solution
Remove any paper in the printer. Press the
30 seconds. Then press it again. Turn the printer off, wait a few seconds,
and then turn it on and try printing again. If the error is not cleared,
contact EPSON as described in the Introduction.
Solution
Remove the packing material, following the instructions on the Notice
Sheet in the box.
Turn off your printer, wait a few seconds, and turn it on again. If the lights
still flash or stay on, contact EPSON as described in the Introduction.
Solution
Press down on the clamp to lock it into place.
Remove the packing material, following the instructions on the Notice
Sheet in the box.
If the printer is not moving or making noise, but the light is still flashing
after 10 minutes, turn the printer off. If the light is still flashing when you
turn it back on, contact EPSON as described in the Introduction.
Solution
Reinstall the printer software after installing Windows 95, as described in
the Quick Setup booklet.
Solution
Click Do not install a driver, and then click OK.
6-8
load/eject button for about
power light is still flashing