Outdoor Unit Installation; Refrigerant Pipe Installation - Carrier 40QSM009DS Service Manual

Tighten the screws under the panel hooks till
the panel closely stick on the ceiling to avoid
condensate water.
Hang the air-in grill to the panel, then connect
the lead terminator of the swing motor and that
of the control box with corresponding
terminators on the body respectively.
Install the 4 corner covers back.
Note: The panel shall be installed after the
wiring connected.

13.3 Outdoor unit installation

13.3.1 Service space for outdoor unit
(Wall or obstacle)
Air inlet
More than 30cm
(11.81in)
Air inlet
Air outlet
More than 30cm(11.81in)
Maintain channel
More than 60cm
(23.62in)
More than 200cm(78.74in)
More than 60cm
(23.62in)
H
13.3.2 Bolt pitch
D
For the value of A,B and D, please refer to
the dimension part.
14.3.3 Install the Unit
Since the gravity center of the unit is not at its
physical center, so please be careful when
lifting it with a sling.
Never hold the inlet of the outdoor unit to
prevent it from deforming.
Do not touch the fan with hands or other
objects.
Do not lean it more than 45, and do not lay it
sidelong.
Make concrete foundation according to the
specifications of the outdoor units.
Fasten the feet of this unit with bolts firmly to
prevent it from collapsing in case of earthquake
or strong wind.

13.4 Refrigerant pipe installation

13.4.1 Maximum pipe length and height
drop
66
W1
W
A
B