Adjusting The Tear-Off Position - Epson Stylus 1500 Reference Manual

1. Make sure the printer is turned on.
2. Press the LF/FF button to load a sheet of paper to the
top-of-form position.
3. Hold down the Pause button for about three seconds. Both
of the font lights begin to flash.
4. Press the Micro Adjust D button to feed paper forward,
or press Micro Adjust U to feed paper backward. (Press
either button as many times as necessary until you reach
the desired position.)
5. To complete the adjustment, press the Pause button. The
new loading position is stored in the printer's memory.
6. Send data from the computer to start printing.
Note:
Your setting remains in effect until you change it again, even if you
turn off the printer.
The printer has a minimum and maximum loading position, beyond
which the paper stops moving.

Adjusting the Tear-Off Position

When you press the Load/Eject button after you have finished
printing a page of continuous paper, you may find that the
perforation is not aligned with the tear-off edge. You can use
micro adjust mode to adjust paper to the tear-off edge. When
you resume printing, the printer feeds paper back to the
loading position.
Paper Handling
1-29