POTS Connection
Use
1. Trim the insulation for the subscriber POTS cables.
2. Connect the twisted pair Tip (green) and Ring (Red) to the RJ-11 connector using an RJ-
3. Insert the RJ-11 connector in the appropriate PHONE 1 or PHONE 2 jack on the back of
Ethernet Connection
For Ethernet connection, complete the following steps:
1. Strip back the jacket of the subscriber Ethernet cable and connect the 4 pair twisted wires
Ethernet RJ-45 Pin-out
Pin
1
2
3
4
5
6
7
8
2. Insert the terminated connector in the appropriate ETHERNET 1 - 4 socket on the back of
612877AEONT-5B
Figure 2-2
when installing POTS, Ethernet, Fiber Optics, and UPS connections.
PHONE 1
PHONE 2
11 Crimper.
the ONT.
to the RJ-45 Plug using a RJ-45 crimper. Refer to
Outs.
Table 2-3. Ethernet Cable Pin-Outs
Name
TRD0+
TRD0-
TRD1+
TRD2+
TRD2-
TRD1-
TRD3+
TRD3-
the ONT.
Section 2, Single Family Unit Indoor Installation
ETHERNET
1
2
3
4
Figure 2-2. ONT Rear Panel
Table 2-3
Description
Transmit/Receive Positive
Transmit/Receive Negative
Transmit/Receive Positive
Transmit/Receive Positive
Transmit/Receive Negative
Transmit/Receive Negative
Transmit/Receive Positive
Transmit/Receive Negative
NET
for a list of Ethernet Cable Pin-
Color Code
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
2-5