Installation Of Mx-80 Type Ii; Unpacking; Unpacking Steps; Repacking Steps - Epson MX-80 Operation Manual

INSTALLATION OF MX-80 TYPE II

1. Unpacking

Before removing the MX-80 Type I I from the carton, check the box for evidence
of shipping damage or mishandling. If such evidence is present, notify the carrier
immediately.

1.1. Unpacking steps

Unpacking steps are as follows:
STEP 1. Open the carton.
STEP 2. Remove accessories.
STEP 3. Remove the MX-80 Type I I holding its underside and lifting it straight
up with the packing material attached.
STEP4. Place the Printer with the packing material on a table or any other
convenient flat surface.
STEP 5. Take off the packing material carefully.
STEP 6. Remove the vinyl cover.

1.2. Repacking steps

Repacking can be carried out by following the above steps in the reverse order.
(Repacking: Shipment for repair, storage, etc.)
NOTE: It is recommended that all original packing materials be saved for reuse in case the
MX-80 Type II requires reshipment in the future.

2. Counting the Parts

The MX-80 Type II and standard accessories are as shown in Fig. 2. Upon unpack-
ing, if you notice any listed contents missing or evident damage, contact the store
where you purchased the MX-80 Type I I as soon as possible.
- 3 -