Fig. 44 Setting Of Cut Paper Sheet; Fig. 45 Printer With Cut Paper Sheet Set Completely - Epson MX-80 Operation Manual

NOTES: 1. The Paper End Detector function may be disabled under software
Push the scale back into position and put the printer lid on the Printer.
STEP 8.
(See Fig. 45.)

Fig. 45 Printer with Cut Paper Sheet Set Completely

Fig. 44 Setting of Cut Paper Sheet

control (ESC 8; refer to page 66) provided printing is left off within
7.5 mm from the paper bottom edge.
2. If the paper is set on the line marked l/4 as shown in Fig. 44, then
the printing starts from a position 28.6 mm below the top edge of the
paper. If the paper is set on the line marked l/8, then the printing
starts from a position 30.2 mm below the top edge of the paper.
- 3 3 -