Stihl FS 260 Instruction Manual page 15

4 Mounting the Bike Handle
2
► Raise the grip of the wing screw (7) to the
upright position.
► Turn the wing screw counterclockwise as far
as stop.
► Push the wing screw into the handle support
as far as stop and then screw it down – but do
not finally tighten yet.
► Adjust the handlebar (2) so that distance A is
no more than 15 cm.
► Line up the handlebar at a right angle to the
drive tube.
► Turn the wing screw clockwise as far as stop.
► Fold the grip of the wing screw down so that it
is flush.
0458-743-0121-E
7
4.4 FS 260: Fitting the throttle
cable
NOTICE
Do not kink the throttle cable or lay it in tight radii
– make sure the throttle trigger moves freely.
► Position the clamp (13) and handle sup‐
port (12) against the drive tube.
► Close the throttle cable retainer (13). The
retainer (13) snaps into place.
4.5 Adjusting the Handlebar
Opening the wing screw
► Raise the grip of the wing screw to the upright
position.
English
13 12
12
13
15