English
► Take out the screw (3) and remove the nut (4)
from the control handle (5).
6
2
7
► Line up control handle (5) in relation to handle‐
bar (2): Throttle trigger (6) must point toward
the gearbox and the clamp screw (7) toward
the engine.
8
2
8
14
5
5
4
3
► Holding the control handle (5) in that position,
push it on to the end of the handlebar (2) and
line up the holes (8).
► Fit the nut (4) in the control handle (5), insert
the screw (3) and tighten it down firmly.
4.3
Assembling the Handle Sup‐
port
To assemble the swiveling handle support it is
necessary to fit a spring in the clamps and
secure them to the handle support on the
machine.
► Use the spring (9) from the parts kit supplied
with the machine.
► Place the spring (9) in the lower clamp mold‐
ing (10).
1
2
► Position the clamp moldings (1) with handle‐
bar (2) on the handle support (11).
4 Mounting the Bike Handle
9
10
A
11
0458-743-0121-E