Haier HWM105-M186 Owner's Manual page 18

Disposal after washing
Cleaning the overflow filter
On Models HWM130-M186,HWM150-M186
Too much lint in the overflow filter will influence normal usage of the machine.
Remember to clean it once every two months.
1.Take off the overflow filter.
Nip the elastic fixing claw and pull in the
direction of the arrow to remove (as
demonstrated in the figure to the right).
2.Clean the overflow filter.
Clean the lint around the filter and flush
with tap water.
3.Re-install the overflow filter.
a.Install the corrugation pipe.
b.Attach the mounting plate at the bottom
of the filter into the valve cover.
c.Hang the hook on the left upper side.
d.Push in the upper part.
Cleaning the unit
Wipe the entire unit with a
soft dry cloth.
Use neutral detergent to wipe
if the machine is excessively
dirty.
Do not apply water directly
when cleaning.
Petrol
Alcohol
After washing, disconnect the water intake hose.
Do not store water in the machine for long
periods of time. Drain the water immediately after
each use.
Pull out the power plug and hang up the power
cord.
Hang up the drain hose. Wipe off water drops on
the surface and inside the machine with a clean
soft cloth.
Open the cover of the wash cycle compartment
Thinner
and the inner/outer covers of the spin cycle
compartment for a short period (about one hour),
then close them.
16
Elastic fixing claw
Hook