Assembly - Husqvarna 125B Operator's Manual

• Make sure that a leak cannot occur when you
move the product or fuel container.
• Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
sure that the storage area does not contain an
open flame.
• Only use approved containers when you move
the fuel or put the fuel into storage.
• Empty the fuel tank before long-term storage.
Obey the local law on where to dispose fuel.
• Clean the product before long-term storage.
• Remove the spark plug cable before you put the
product into storage to make sure that the engine
does not start accidentally.
WARNING:
chapter before you assemble the
product.
To install the the blower tube and
nozzle on the product
Note:
The bolt must be sufficiently loose to put the
blower tube into the blower outlet. Turn the bolt
counterclockwise with a screwdriver to loosen it.
1. Align the rib on the upper blower tube with the
groove in the blower outlet. Move the tube into
position.
2. Turn the bolt clockwise with a screwdriver to
attach the tube.
Note:
Do not use any tool on the nut.
3. Align the slots on the lower blower tube with the
tabs on the upper blower tube. Move the lower
blower tube onto the upper blower tube.
4. Turn the lower blower tube clockwise until there
is a click.
To install the blower tube and nozzle
Note:
Make sure to install the tube clamp bolt and
tube clamp nut before use.
1. Loosen the tube clamp bolt.
2. Align the slot in the blower air outlet with the rib
on the tube.
3. Push the tube until the the holes in the tube and
housing align.
4. Tighten the tube clamp bolt.
5. Twist the nozzle to the right until you feel a click.
8

Assembly

Read the safety
Safety instructions for maintenance
WARNING:
can result in serious engine damage or
in serious injury.
The owner is responsible for the performance of all
necessary maintenance as specified in the
operator's manual. Disconnect the spark plug before
maintenance. Do not disconnect the spark plug
before carburetor adjustments.
To install the collection bag with
different vacuum tubes
WARNING:
before you attach the the tubes to the
product.
To assemble the collection bag
1. Open the collection bag.
2. Insert the collection bag tube from inside of the
bag to fit in the vacuum inlet opening.
3. Make sure that the elastic seats in the groove
(A).
4. Close the zipper on the bag.
A
To install the collection bag tube
1. Remove the blower tube, if it is attached.
2. Align the rib on the collection bag tube (A) with
the groove in the blower outlet (B).
3. Push the collection bag tube fully onto the blower
outlet.
4. Insert the nut (C) in its opening.
Incorrect maintenance
Turn off the engine
214 - 008 - 23.09.2021