Sharp MX-B356W Quick Start Manual page 22

BEFORE USING THE MACHINE
Loading envelopes
When inserting envelopes in the bypass tray, place them
aligned to the left side in the orientation shown below.
Only the front side of envelopes can be printed or copied
on. Place the front side facing down.
Fold the flap and make a sharp crease at the fold.
When printing the front side
Place the front side facing down.
Fusing unit release levers (Loading envelopes)
In some cases damage to the envelopes or smudging may occur even if envelopes within the specifications are used.
This problem may be alleviated by shifting the fusing unit release levers from their "normal pressure position" to the
"lower pressure position". Follow the procedure on this page.
• Move the fusing unit release levers (two) to the lower pressure position as shown.
• Return the lever to the normal position when finished feeding envelopes.
A
• Before printing envelopes, it is recommended that you conduct a test print.
• When loading envelopes in the bypass tray, set the paper type.
CHANGE THE SETTING OF THE PAPER TRAY (page 23)
►
22
When placing DL
• Place so that the flap is on the right.
• When using an envelope, you must rotate the image
180 degrees if needed. For more information, see
"User's Manual".
A
B
Flap Open the flap of the envelope.
Address printing
Place the front side facing down.
Normal position
Lower pressure position
B