Epson WorkForce 610 Series Quick Manual page 43

4. Before you open the new cartridge
package, shake it gently four or five
times. Then remove the cartridge
from the package. Do not touch the
green chip on the side.
5. Remove the yellow tape from the
bottom of the ink cartridge.
Caution:
Do not remove any other labels or seals, or ink may leak.
6. Insert the new ink cartridge into the holder and push it down until it clicks
into place.
7. Once you replace all the cartridges that need replacing, close the cartridge
cover and push it down until it clicks into place.
8. Lower the scanner.
9. Press to begin charging the ink. This takes about 3 minutes. When you
OK
see a completion message on the display screen, ink charging is finished.
Caution:
Never turn off your product while ink is charging or you'll waste ink. If you see an ink
replacement message on the display screen, press OK and press down all the
cartridges securely. Then press OK again.
Note:
If you replaced a cartridge while copying a document or photo, cancel printing and
make sure your original is still placed correctly on the scanner glass. Then copy your
original again.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.
Replacing Ink Cartridges
43