Specifications - ActionTec WEB7200 User Manual

WEB7200 WiFi 6 Repeater
configure various administrative aspects of the Extender and its GUI. They should be adjusted by an
experienced network technicians only.
Management
The Management screen allows the Extender's IP address settings to be modified. Only experienced
network technicians should change these settings.
Factory Default
The Factory Default advanced setup screen allows the Extender's factory default settings to be
reapplied, erasing all current settings. Click Restore Default Settings to restore the Extender to its
factory default state.
Firmware Restore
The Firmware Restore screen lists the active and backup firmware versions available on the Extender.
Click Swap Firmware to switch the active firmware to the backup firmware, and vice versa.
Firmware Auto Upgrade
The Firmware Auto Upgrade screen allows the user to designate a web link that the Extender checks
periodically for firmware upgrades. To use, click on the Enable button to activate, enter the appropriate
web address in the Check URL text box, then click Apply.
Firmware Upgrade
Actiontec periodically posts firmware upgrades that may include enhancements and/ or bug fixes for the
Extender. To upgrade the Extender's firmware:
1. Go to http:/ /www.actiontec.com/ support/ to discover the latest firmware available for the Extender.
If the version is the same as the current version applied to the Extender, there is no need to upgrade the
firmware. If the online version is newer, download it to a notebook computer.
2. Make sure that this computer is connected to the Extender via Ethernet.
3. Locate the firmware file by clicking Browse.

Specifications

Model Number
WEB7200
Protocol/Standards/Support
Wireless IEEE 802.11ax
Ethernet IEEE 802.3/802.3u/802.3ab 10/100/1000 Base-T
LAN Interfaces
Two 10/100/1000 Ethernet Ports
Antennas
2x2 internal 2.4 GHz
2x2 internal 5 GHz
Company Confidential. 8