ActionTec WEB7200 User Manual page 10

WEB7200 WiFi 6 Repeater
• Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do
not install near any heat sources such as radiators, heat registers, stoves, or other apparatus including
amplifiers that produce heat.
• Do not use the telephone to report a gas leak in the vicinity of the leak.
• Use only the power cord indicated in this manual if applicable.
FCC Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
and correct the interference by implementing one or more of the following measures:
• Reorient or relocate the device;
• Increase the separation between the equipment and receiver;
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
(applicable only to powerline products);
• Consult the dealer or an experience radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are
not expressly approved by Actiontec Electronics, Inc., may void the user's authority to operate the
equipment.
Declaration of Conformity
Declaration of Conformity for Products Marked with the FCC logo or Industry Canada (IC)- North
America Only
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
1. This device may not cause harmful interference;
2. This device must accept any interference received, including interference that may cause undesired
operation of the device.
Company Confidential. 10