Table of Contents
Advertisement
Setting and Indication of the Control PCB
Switch Setting
(1) Auto/Forced selection switch (Slide switch, SW14)
SW14
Auto (自動)
Forced (強制)
(2) Control/Check selection switch (Slide switch, SW15)
SW15
Control (制御)
Check (チェック)
(3) Model setting switch (DIP switch, SW13)
The following functions can be selected. Change setting as required.
Switch setting at factory shipment is all "OFF."
SW13
Function
Auto operation
Forced operation
Function
Normal mode
Special mode
Function with ON
No.
1
Evacuation
2
Without controller communication
3
4
5
6
PCB inspection
7
Back mode 2
8
Back mode 1
Remarks
Normal operation setting
Not in use
Remarks
Normal operation setting
PCB inspection, Evacuation setting
Note: The DIP switch SW13 setting
is also required.
Remarks
No.6: OFF, SW15: Check (チェック)
―
Inoperable
No.1: ON, SW15: Check (チェック)
No.3, No.5, and No.8: OFF
No.3, No.5, and No.7: OFF
27
Advertisement
Table of Contents
