Section 3 Operation Of Target Tracking; Acquiring A Target; Auto Acquisition (Automatic Acquisition) Mode - JRC JMR-5410-6X Simplified Instruction Manual

Section 3
3.1

Acquiring a Target

The methods for acquiring targets include Auto Acquisition (automatic acquisition) mode and ACQ
MANUAL (manual acquisition) mode.
Both modes can also be used concurrently.

3.1.1 Auto acquisition (automatic acquisition) mode

By setting up and enabling the automatic acquisition/activation zone (AZ), targets intruding into the
AZ can automatically be acquired/tracked and at the same time, a New Target Alarm (automatically
acquired target alarm) can be issued.
Memo
If manual acquisition is made in a state in which the number of targets being tracked has reached
the maximum number of targets, the target with the lowest danger level among the targets that
have been captured thus far automatically is erased successively.
When all the targets that are tracked are for manual acquisition and the number has reached the
maximum number of targets, no further acquisition is allowed.
[Operation procedure]
Open the New Target Alarm setup screen by performing the following menu operations.
[Menu] button → Alert → New Target Alarm
1
Enable the automatic acquisition/activation zone (AZ) by checking [Use AZ1] or [Use
AZ2].
Automatic acquisition/activation zone (AZ) includes AZ1 and AZ2.
To enable AZ1, check [Use AZ1].
To enable AZ2, check [Use AZ2].
To automatic acquisition/activation zone (AZ):
Clear the check of [Use AZ1] or [Use AZ2].
AZ can be enabled or disabled by using the [AZ] key on the operation unit also.
Operation of Target Tracking
3-1

Section 3 Operation of Target Tracking

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1