Placing Originals For Copying Or Scanning; Placing Large Or Thick Documents; Copying A Document - Epson Stylus CX4800 Series User Manual

Placing Originals for Copying or
Scanning
Caution:
Do not place heavy objects on the document table glass and do not
press the glass with too much force.
1. Open the document cover and place your original face-
down on the glass, in the upper left corner. Move your
original about 0.04 inch (1 mm) away from the top and left
edges so all of it will be scanned.
2. Close the document cover gently so that your original does
not move.
Caution:
Never open the document cover beyond where it stops and do
not place heavy objects on top of the Epson Stylus CX all-in-one.
Epson Stylus CX4200 Series/Epson Stylus CX4800 Series

Placing Large or Thick Documents

When you scan a large or thick document, you can remove the
document cover. Just open it and pull it straight up.
If you need to press the document flat while you copy or scan
it, do not press too hard and be careful not to move it.
Caution:
Do not use excessive force on the document cover, and do not
twist it diagonally. You may damage the document cover.
When you are done, replace the document cover by inserting
the tabs back into the slots.
Copying
Using the Epson Stylus CX buttons, you can make copies
using either letter-size (8.5 × 11-inch) plain paper, or
letter-size, 4 × 6-inch, or 5 × 7-inch photo paper.

Copying a Document

1. Make sure the Epson Stylus CX is turned on.
2. Place the document on the glass as described to the left. Be
sure to close the document cover.
3. Load up to 100 sheets of letter-size plain paper. (See page 4
if you need instructions.)
5/05
7