Windshield Washer Fluid; Adding Washer Fluid - Cadillac Escalade 2004 Escalade ESV Owner's Manual

What to Use
To determine what kind of fluid to use, see
Recommended Fluids and Lubricants on page 6-12.
Always use the proper fluid. Failure to use the proper
fluid can cause leaks and damage hoses and seals.

Windshield Washer Fluid

What to Use
When you need windshield washer fluid, be sure to read
the manufacturer's instructions before use. If you will
be operating your vehicle in an area where the
temperature may fall below freezing, use a fluid that has
sufficient protection against freezing. See Engine
Compartment Overview on page 5-10 for reservoir
location.

Adding Washer Fluid

Your vehicle has a low washer fluid message that
comes on when the washer fluid is low. The message is
displayed for 15 seconds at the start of each ignition
cycle. When the LOW WASHER FLUID message
is displayed, you will need to add washer fluid to the
windshield washer fluid reservoir.
5-36
Open the cap with the washer symbol on it. Add washer
fluid until the tank is full.
Notice:
•
When using concentrated washer fluid, follow
the manufacturer's instructions for adding
water.
•
Do not mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and
damage your washer fluid tank and other parts
of the washer system. Also, water does not
clean as well as washer fluid.
•
Fill your washer fluid tank only three-quarters
full when it is very cold. This allows for
expansion if freezing occurs, which could
damage the tank if it is completely full.
•
Do not use engine coolant (antifreeze) in your
windshield washer. It can damage your washer
system and paint.
The windshield washer
fluid reservoir is located in
the engine compartment
toward the front of the
vehicle on the driver's side.