Using Homelink; Resetting Defaults - Cadillac Escalade 2004 Escalade ESV Owner's Manual

®

Using HomeLink

Press and hold the appropriate HomeLink
least half of a second. The indicator light will come
on while the signal is being transmitted.
Erasing HomeLink
To erase programming from the three buttons do the
following:
1. Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
2. Release both buttons. Do not hold for longer than
30 seconds.
®
HomeLink is now in the train (learning) mode and can
be programmed at any time beginning with Step 2
under "Programming HomeLink
Individual buttons can not be erased, but they can be
reprogrammed. See "Reprogramming a Single
®
HomeLink Button" next.
®
button for at
®
Buttons
®
."
Reprogramming a Single HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink ."

Resetting Defaults

®
To reset HomeLink to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
1-800-355-3515, or on the internet at
www.homelink.com.
®
® ®
using a HomeLink
®
button. Do
®
®
®
at
2-41