Mounting Lcd To The Wall - Envision E218C1 User Manual

Mounting LCD to the wall

Preparing To Install The Optional Wall Mount Arm (not included)
This monitor can be attached to a wall mounting arm you can purchase separately.
Turn the power OFF then disconnect the cables from the monitor before performing the
procedure below. Lay the monitor face down on a soft surface.
1. Remove the 4 screws at the back of the monitor which connect the stand base to the
monitor.
2. Remove the stand base.
Attaching The Optional Wall Mount Arm (not supplied)
Follow these steps to finish installing the wall mounting arm:
1. Place the wall mounting arm onto the back of the monitor. Line up the holes of the arm
with the holes in the back of the monitor.
2. Insert the 4 screws into the holes and tighten. (M4 x 10mm)
3. Reconnect the cables. Refer to the user's manual that came with the optional wall
mounting arm for instructions on attaching it to the wall.
13