Akai AK-10KGTLW Instruction Manual page 10

Getting Started: Installation (Cont.)
CAUTION:
inlet valve joint. Apply force evenly and do not twist the water inlet valve.
CAUTION:
use a hose from an existing machine, or one that has been used previously.
CAUTION:
advice from your local washing machine store to purchase a longer hose.
Installing the drain hose
• The drain hose and drain pump filter are located at the back of the machine, as
illustrated below, left.
• Pinching the two bands of the clamp on the drain hose, connect it to the drain hose
connection at the back of the washer, as illustrated below.
• When the washer is in use, put the drain hose into a drain spout (or into a sink/tub),
as illustrated on the opposite page.
10
When tightening the clamping nut, take care not to damage the water
Use only the new (supplied) hoses with your new appliance. Do not
In the event that the hoses are too short for your set-up, please seek
Drain pump with
Drain hose
lint filter
connection
(AU) 1300 886 649 (NZ) 0800 836 761 |
After Sales Support
info@tempo.org