Trane Thermo King T-590 Series Installation Manual page 40

Self-powered truck edition single temperature systems

Table of Contents

Steel or Aluminum Tank

I I m m p p o o r r t t a a n n t t : : Safety precautions must be followed. Refer to F F u u e e l l S S y y s s t t e e m m C C o o m m p p o o n n e e n n t t I I n n s s t t a a l l l l a a t t i i o o n n H H a a z z a a r r d d s s located in

the S S a a f f e e t t y y P P r r e e c c a a u u t t i i o o n n s s section of this manual before proceeding.

N N o o t t e e : : The fuel pickup tube supplied in the installation kit will not be needed when also installing an optional Thermo

King aluminum fuel tank. The aluminum tank is already equipped with fuel inlet, fuel outlet and vent fittings.

E E P P A A C C O O N N F F O O R R M M A A N N C C E E : : The fuel tank must have a label on the fuel inlet (fill spout) stating " ULTRA-LOW-SULFUR FUEL

ONLY". Verify label is present. If not present, order label 93-1184 and install on tank. Reference 40 CFR 1039.104(e)/

1039.135

I I M M P P O O R R T T A A N N T T I I N N S S T T A A L L L L A A T T I I O O N N T T I I P P S S

•

BEFORE drilling any holes, check for internal baffles inside the tank.

•

PRIOR to installation, remove protective caps from ends of pickup tubes.

•

DO NOT apply any type of sealant material to the fuel pickup tube assembly. Doing so will result in plugged fuel

lines.

N N o o t t e e : : Use a magnet, grease or special hole saws/drills that will minimize debris from entering the fuel tank. Thoroughly

clean and flush the tank to remove any debris.