I I N N S S T T A A L L L L I I N N G G U U S S B B D D O O W W N N L L O O A A D D P P O O R R T T ( ( O O P P T T I I O O N - Trane Thermo King T-590 Series Installation Manual

Installing HMI Controller
I I m m p p o o r r t t a a n n t t : : HMI should be installed in an area inside the cab that is accessible to the driver while not interfering with
the safe operation of the truck.
I I N N S S T T A A L L L L A A T T I I O O N N M M E E T T H H O O D D S S
1. Choose installation method that best meets your needs:
D D I I N N M M o o u u n n t t i i n n g g — Supplied DIN (ISO 7736) mounting sleeve allows controller to be installed directly into driver's
panel. Make sure tabs are bent out as shown to secure sleeve into panel opening.
L L - - B B r r a a c c k k e e t t s s — Supplied L-Brackets allow controller to be installed on top or underneath driver's panel. Use supplied
#8 screws and #8 flat washers to attach L-Brackets to controller. Installer to supply hardware to secure to driver's
panel.
2. Route controller harness from unit to inside cab.
I I m m p p o o r r t t a a n n t t : : Route and secure controller harness to prevent rubbing, chafing or making contact with sharp, moving
or hot components. Allow excess length harness for tilt cab applications. Supplied rubber grommets
must be used when routing harness through sheet metal holes.
3. P P r r e e m m i i u u m m H H M M I I C C o o n n t t r r o o l l l l e e r r ( ( S S t t a a n n d d a a r r d d ) ) — Connect adapter harness 8-pin connector to mating connector on
controller harness.
a. Attach flat plastic adapter harness connector to rear of controller and secure with supplied #10 screws and
washers.
B B a a s s i i c c H H M M I I C C o o n n t t r r o o l l l l e e r r ( ( O O p p t t i i o o n n a a l l ) ) — Connect controller harness directly to rear of controller until it locks firmly in
position. Adapter harness is not used with this controller.
a. Lightly pull on harness to confirm it is locked securely.
4. Attach supplied OPERATOR'S MANUAL nameplate near HMI.
TK 56700-1-IM-EN
Figure 27. Typical Installation Methods Shown
RCS1087-3
39