Step 5; Figure 9 - Husky CWR48B Use And Care Manual

Assembly Instructions

Step 5

Assemble one Shelf Clip-L (L), one Shelf Clip-R (M) and one Shelf Support (C) to the welded brackets by lining up
the holes of both shelf clips with the oblong holes located on the top rear of the welded brackets. See figure 9 for
correct positions for Shelf Clip-L (L) and Shelf Clip-R (M). Next, place and lineup the Shelf Support end holes onto the
lined-up holes of the Shelf Clips and welded brackets. Bolt together using one Carriage Bolt (H), one Lock Nut (I) and
one Small Washer (J) per side. Repeat the same steps to assemble one Shelf Clip-L (L), one Shelf Clip-R (M) and one
Shelf Support (C) to the oblong holes located on the top front of the welded brackets in the same manner. Again, see
figure 9 for correct positions for Shelf Clip-L (L) and Shelf Clip-R (M).

Figure 9

M
C
L
C
L
M
✓
Tool(s):
7/16"Socket
Wrench
Step 6
Install the two Center Supports (D) by fitting the end tabs into the two verticle oblong holes located on the top
center of both welded brackets (see Figure 10).
Figure 10
D
✓
D
5