Related Manuals for CDA HE6051FR
Summary of Contents for CDA HE6051FR
- Page 1 Electric Hob Installation, Use and Maintenance Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu www.cda.eu...
-
Page 2: Table Of Contents
Contents: Important Important Notes Using Your Hob Efficient Use Of Your Hob Care And Maintenance Fitting The Hob How To Install The Hob Mains Electricity Connection... -
Page 3: Important
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment. - Page 4 EU Declarations of Conformity: This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (2014/35/EU - LVD) and Electromagnetic interference compatibility (2014/30/EU - EMC). Parts intended to come into contact with food conform to 1935/2004/EC..
-
Page 5: Important Notes
Important Notes Please note: • • Electric hobs become hot and remain hot during and immediately after use. We strongly advise that you do not touch the hob until it has been allowed to cool. If wiping away a spillage, please take every care not to burn yourself. -
Page 6: Using Your Hob
Using Your Hob Fig.1 Electric hotplates: 1. 180mm (FL) 2.0kW 2. 145mm (BL) 1.5kW 3. 180mm (BR) 1.5kW 4. 145mm (FR) 1.0kW Control knobs: 5. Back right 6. Back left 7. Front left 8. Front right Fig.2... - Page 7 HOTPLATE SWITCHES: The power of each hotplate can be varied using the control knob to select the required heat. The table below shows the heat at each of the 6 settings: Heat setting Description Recommended use Very gentle Stewing vegetables Gentle Boiling potatoes Slow...
-
Page 8: Efficient Use Of Your Hob
Efficient Use Of Your Hob The hob is equipped with hotplates of different sizes, designed to accommodate most shapes and sizes of pan. For best results, only use pans with flat bottoms and choose an appropriate hotplate depending on the size of the pan. The most efficient use of the hob is shown below, where the pan and hotplate are correctly chosen. -
Page 9: Care And Maintenance
Care and Maintenance The hob has a stainless steel surface. Due to this you should use a non-abrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. Stainless steel can be effectively cleaned by simply using a dilute solution of water and washing up liquid and drying to a shine with a clean cloth. - Page 10 1. Check that the mains supply has not been switched off. 2. Check that the fuse or circuit breaker has not blown/tripped. If one or more plates continue to malfunction, please contact CDA Customer Care. Contact details can be found below.
-
Page 11: Fitting The Hob
Fitting The Hob Unpacking the hob: • Take care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 150mm away from any adjacent vertical surfaces, e.g. -
Page 12: How To Install The Hob
Notes: • Do not position this appliance above a refrigeration unit. The heat generated may cause the unit to fail. • This appliance is designed to be installed into cabinet units capable of withstanding temperatures of 65°C above ambient or greater (typically 80-90°C). - Page 13 cable clamp. Secure the plate in place with the screws provided. >61.5mm 490mm >600mm 560cm 560mm 185mm 185mm >165mm >165mm Fig.4 Fig.5 Fig.6 Fig.7 = Brass/Copper bridge link Fig.8 TECHNICAL DATA: The table below shows the rated output of each hotplate: Mains electrical voltage: 230 - 240Vac, 50Hz Total rated electrical input: 5.5kW Hotplate Size...
-
Page 14: Mains Electricity Connection
Mains Electricity Connection Warning! this appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.T. and local regulations. This appliance is intended to be connected to fixed wiring and is not suitable for connection to a 13A plug or 13A supply. - Page 15 FR:208.9 / RL:208.9 / RR:208.9 Energy consumption for the hob 208.9 Wh/kg Electric hob calculated per kg E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the right to change specifications without prior notice.
- Page 16 Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu www.cda.eu...