Table of Contents
Advertisement
CONTROL KNOB
MILLIVOLT GAS CONTROL VALVE
Figure 4
Millivolt Appliance Lighting
To light millivolt appliances refer to the detailed
lighting instructions found in both English and
French on pages 10 and 11 of these instruc-
tions respectively. Appliance lighting instruc-
tions may also be found on the pull-out label
located near the gas valve in the control
compartment. Refer to Figure 1 for the piezo
ignitor location used with your appliance.
Your appliance comes supplied with remote
wall switch or can be used with an optional
remote control kit. The appliance main burner
may be turned on and off with the wall switch
or remote control.
Electronic Appliance Lighting
To light electronic appliances refer to the de-
tailed lighting instructions found in both En-
glish and French on pages 12 and 13 of these
instructions respectively. Appliance lighting
instructions may also be found on the pull-
out label located near the gas valve in the
control compartment.
Your appliance comes supplied with remote
wall switch or can be used with an optional
remote control kit. The appliance main burner
may be turned on and off with the wall switch
or remote control.
1. When lit for the first time, this appliance will
emit a slight odor for an hour or two. This is
due to the "burn-in" of internal paints and
lubricants used in the manufacturing process.
2. Keep lower control compartment clean by
vacuuming or brushing at least twice a year.
More frequent cleaning may be required due to
excessive lint from carpeting, bedding materi-
als, etc. It is important that control compart-
ments, burners and circulating air passage-
ways of the appliance be kept clean.
3. Always turn off gas to the pilot (millivolt
appliances) before cleaning. Before re-lighting,
refer to the lighting instructions in this manual.
Appliance lighting instructions may also be
found on the pull-out label located near the
gas valve in the control compartment.
4
ON/OFF SWITCH
P
C
M
ELECTRONIC GAS CONTROL VALVE
Figure 5
4. Always keep the appliance area clear and
free from combustible materials, gasoline and
other flammable liquids.
5. Remember, Millivolt appliances have a con-
tinuous burning pilot flame. Exercise caution
when using products with combustible vapors.
6. Clean the optional glass doors only when
necessary. Wipe surface with clean, damp-
ened, soft cloth. Follow with dry, soft towel as
desired. Take care not to scratch the glass
surface.
WARNING: DO NOT USE ABRASIVE
CLEANERS. NEVER CLEAN THE GLASS
WHEN IT IS HOT.
CAUTION: DO NOT ATTEMPT TO TOUCH THE
DOORS WITH YOUR HANDS WHILE THE FIRE-
PLACE IS IN USE. ALWAYS USE DOOR
HANDLES. DOORS WILL BECOME VERY HOT
WHEN FIREPLACE IS IN USE.
WARNING: FIREPLACES EQUIPPED
WITH OPTIONAL ACCESSORY DOORS
SHOULD BE OPERATED ONLY WITH THE
DOORS FULLY OPEN OR FULLY CLOSED
(FIGURE 6). THIS APPLIANCE MAY ONLY
BE FITTED WITH DOORS CERTIFIED FOR
USE WITH THE APPLIANCE.
AVERTISSEMENT: POUR UTILISATION
UNIQUEMENT AVEC LES PORTES EN
VERRE CERTIFIÊES AVEC L'APPAREIL.
Glass Doors
Fully Open or
Fully Closed
(Bi-Fold Doors)
Figure 6
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Outside Combustion Air Controls
Appliances may be installed with an outside
(make-up air) vent system that is designed to
provide the appliance with outside make-up
air for combustion when in operation. The
shut-off lever for the outside air system is
standard on all appliances but should not be
operated if the complete system is not in-
stalled. Refer to Figure 7 for GHC-6500 series
units and Figure 8 on page 5 for GRD-6500
series units. When the complete outside air
vent system is installed, the installer will re-
move the cover from the shut-off lever located
in the left side of the firebox opening.
If your cover is not removed and you have
reason to believe that you have a complete
outside air system, contact your distributor to
have your appliance inspected for the presence
of the complete system. DO NOT assume that
you have this system in place.
The hand operated shut-off lever is located in
the left side of the fireplace opening behind the
screen. To open, pull all the way. The outside
air damper should be fully open when the
fireplace is in use and completely closed when
the fireplace is not being used. This will prevent
outside cold air from entering the dwelling.
(If an optional "All-Glass" enclosure panel has
been installed on the 6500 Series appliances, an
extension bar will have been attached to the
actuator lever as illustrated in Figures 7 and 8 .
Both versions of the actuator lever extension bar
are packaged with the glass enclosure panel.)
WARNING:
DO NOT OPERATE THE
SHUTOFF LEVER UNLESS A COMPLETE
OUTSIDE AIR VENT SYSTEM HAS BEEN
INSTALLED WITH YOUR APPLIANCE.
C
Extension Bar
O
Combustion Air Control Lever and
Extension on GHC-6500 Series Units
Figure 7
Actuator Lever
Phillips Pan
Head Screw
#6-32 x ⁷⁄₃₂"
(6 mm)
Hide quick links:
Advertisement
Table of Contents
