C2H124-48; C2H124-48 Stackable Switch - Enterasys SecureStack C2 C2G124-24 Hardware Installation Manual

Overview

C2H124-48

The C2H124‐48
• RJ45 ports (10/100 Mbps copper ports)
• SFP slots that provide you with the option of installing Small Form Pluggable (SFP)
Mini‐GBICs for 1000BASE‐T compliant copper connections or 1000BASE‐SX/LX fiber‐
optic connections
• Rear panel connectors for high‐speed connections in a stack configuration
• Rear panel Redundant Power Supply connector for a redundant power supply
connection. The switch connects to a C2RPS‐SYS using a C2RPS‐PSM Cable.
The 10/100 Mbps fixed front panel ports can operate in either half‐duplex or full‐duplex
mode, as determined by Auto‐Negotiation.
Figure 1-3
Á
1 DB9 RS232 console port connector
2 Status LEDs
3 Forty-eight RJ45, 10/100 Mbps ports
4 RJ45 port status LED
5 Four slots for SFP interface modules
(Mini-GBICs)
1-4 Introduction
(Figure 1‐3) has the following front panel port connections
Caution: The C2H124-48 is not a PoE-compliant device. Do not connect a SecureStack
C2 PoE Redundant Power System (C2RPS-POE) to the DC power connector. Otherwise,
damage to the device may result.
Precaución: El dispositivo C2H124-48 no cumple con el estándar PoE. No conecte una
fuente de poder redundante (RPS) SecureStack C2 PoE (C2RPS-POE) al cable de
corriente directa. De lo contrario, el dispositivo puede dañarse.

C2H124-48 Stackable Switch

Æ Ç
S
Ã
Â
È
6 Mini-GBIC port status LEDs
7 Two ports for stack connections
8 Reset switch
9 AC power input connector
10 Redundant power supply (RPS) DC
connector
Å
Ä À
É