Inspect The Breaker; Inspect The Voltage Regulator - Kubota GL14000-USA Service Manual

Inspect the Breaker

(10)

Inspect The Voltage Regulator

(11)
1. Measure the resistance among the leads for "yellow and yellow/red" and "yellow and
yellow/green" by the ohm tester. (Reading may not be accurate when the low resistance
tester is used.)
2. The reading shall be 0~10kΩ when the voltage regulator knob turns.
U W
20
1. Shut off engine. Turn the main circuit
breaker OFF.
2. Check the resistance with a
ohmmeter between upper terminal
and lower terminal of;
Upper Terminal
U
W
The ohmmeter should display the symbol
of infinity, ∞, or similar per the
ohmmeter that you may use.
1. Shut off engine. Turn the main circuit
breaker ON.
2. Check the resistance with a
ohmmeter between upper terminal
and lower terminal of;
Upper Terminal
U
W
The ohmmeter should display approx. 1
ohms.
Lower Terminal
U
W
Lower Terminal
U
W