Table of Contents
Advertisement
Delay timer
A delay of up to 24 hours can be added to the end time in half hour
increments to allow the wash programme to finish at a convenient
time. The delay time is to the end of the wash programme not the start
of the programme.
The 'Delay Timer' function is not available for the 'Spin' programme.
To set the delay timer:
•
Press the 'Delay timer button' (written 'start delay').
•
Pressing the 'Delay timer button' again increases the delay by 30
minutes for each press, up to the maximum of 24 hours.
•
Once the required time delay is shown on the display, the washing
machine will set after approximately three seconds delay.
Extra rinse
This function adds an extra rinse cycle to the programme, which is
ideal for large loads and garments belonging to people with sensitive
skin. Please note: this function will increase the water consumption.
Press the 'Additional functions button' once to select the extra rinse,
the display will show an indicator next to the extra rinse writing.
Pre-wash
The prewash function prolongs the washing time by about 20
minutes. The main wash is then preceded by an additional wash cycle
at a temperature of 30°C. This function is recommended for heavily
soiled laundry. Before starting the prewash function, detergent must
be put in the detergent dispenser.
Start / Pause
Press the 'Start / pause button' to start the selected wash programme
running, the indicator light stays on. If this is pressed again while
the machine is running a programme the washer will pause and the
indicator light will flash.
18
Advertisement
Table of Contents
