Users Information Section; Warnings & Cautions - Thermo Pride OME-72T36 Installation And Service Manual

All installations and services must be performed by qualified service personnel.
Do not attempt to start burner when excess fuel has accumulated inside the
:
furnace.
6. Follow the "BURNER OPERATION AND ADJUSTMENT" procedure in Section L.
A. WARNINGS AND CAUTIONS:
If you suspect there is a problem with the furnace, pertaining to the venting
:
system or any other related problem, immediately contact a qualified service agency. If a
service agency is not available, contact your fuel supplier.
Personal injury or property damage could result from major repair or service
:
of this furnace by anyone other than a qualified contractor. The user should only perform
the routine maintenance described in the user section of this manual.
The area around the furnace should be kept free and clear of combustible
:
materials, especially papers and rags.
Never burn garbage or refuse in your furnace. Never try to ignite oil or gas by
:
tossing burning papers or other material into the furnace.
Do not attempt to start the burner when:
:
1. Excess oil or gas has accumulated,
2. The furnace is full of vapors,
3. The combustion chamber is very hot.
If one or more of these conditions exist, contact a qualified service person.
Do not block or obstruct air openings on the furnace casing. Do not block or
:
obstruct air openings communicating within the area in which the furnace is installed.
Do not allow the outside air intake to be blocked or obstructed by vegetation,
:
ice, snow, or any other materials.
Do not use this furnace if any part has been underwater. Immediately call a
:
qualified service agency to inspect the furnace and to replace any part of the electrical or
control system which has been underwater.
Should overheating occur or the fuel supply fail to shut off, shut off the
:
manual fuel supply valve to the furnace before shutting off the electrical supply.
VI. USER INFORMATION SECTION
45