Table of Contents
Advertisement
CLEANING AND SERVICING
Turn off gas logs and allow to cool before
cleaning. Disconnect electrical power if
applicable before cleaning or servicing.
Remove logs, handling carefully by holding gently at each
end. Gloves are recommended to prevent skin irritation
from ceramic fibers. If skin becomes irritated, wash gently
with soap and water. See manual for correct log placement.
PERIODIC CLEANING - SEE PARTS DIAGRAM FOR
LOCATION OF ITEMS DISCUSSED BELOW.
•
Do not use cleaning fluid to clean logs or any part of
gas logs.
•
Logs - brush with soft bristle brush or vacuum with
brush attachment.
•
Vacuum loose particles and dust from the control
and grate weldment.
•
Inspect and clean burner air intake holes. Remove
lint or particles with vacuum or brush. Failure to keep
air intake holes clean will result in sooting and poor
combustion.
•
If embers (rock wool) have turned a rust color and
become brittle, remove old embers (rock wool) from
log set. Replace with new rock wool. Rock wool can
be purchased from your local dealer. See log place-
ment section for placement of embers.
ANNUAL CLEANING/INSPECTION - SEE PARTS
Hearth & Home Technologies • VDY 24/18/30 Gas Log Heater Install/Owner's Manual • 32D1999 • Rev D • 05/19
"Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire
DIAGRAM FOR LOCATION OF ITEMS DISCUSSED
BELOW.
•
•
•
•
•
Inspect and clean all burner ports.
Verify burner and pilot flame pattern and log place-
ment for proper operation.
Verify smooth and responsive ignition of burner.
Inspect and clean chimney.
Inspect and clean burner air intake holes. Remove
lint or particles with vacuum or brush. Failure to keep
air intake holes clean will result in sooting and poor
combustion.
27
Advertisement
Table of Contents
