Table of Contents
Advertisement
Getting started
Setting up the handset for use
The display is protected by a plastic film.
Inserting the batteries
Only use rechargeable batteries, as this could otherwise result in significant health
risks and personal injury. For example, the outer casing of the batteries could be
destroyed or the batteries could explode. The device could also malfunction or be
damaged as a result of using batteries that are not of the recommended type.
Insert the batteries (for
correct +/- direction, see
diagram).
Covering the headset socket
Plug the lug of the rubber cover for the
handset socket into the opening on the left
of the handset.
Press down the cap of the rubber cover.
Charging the batteries
Charge the batteries fully prior to first use in the
charging cradle or using a standard USB mains
adapter.
The batteries are fully charged when the power
icon
disappears from the display.
The battery may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
As soon as power is applied to the handset, a Setup wizard starts.
8
Please remove the protective film!
Line up the battery cover at
the recesses with the inside
of the casing
Press the cover until it
clicks into place.
Availability and operation of the functions
may differ on your telephone.
To re-open the battery cover:
Remove the belt clip
.
3
(if attached).
Use your fingernail to reach
into the recess and pull the
battery cover up
1
.
7 h
Advertisement
Table of Contents
