Water Connection - Zanussi ZSF2430 User Manual

Adjusting the level of the appliance
Make sure that the appliance is level to close and seal the
door correctly. If the level of the appliance is correct, the

Water connection

Inlet hose
The appliance has safety features to prevent that the
water in the appliance goes back into the drinking
water system.
Connect the appliance to a hot (max. 60°) or cold water
supply.
If the hot water comes from alternative sources of energy
that are more environmentally friendly (e.g. solar or pho-
tovoltaic panels and aeolian), use a hot water supply to
decrease energy consumption.
It is important that a water tap or stopcock is near the
dishwasher with easy access.
If the water inlet hose is too short, replace the water inlet
hose with an applicable, longer high-pressure hose. Do
not connect an extension hose.
To suit the installation, it is possible to turn the end of the
hose that is connected to the dishwasher. Do these steps :
Connect the inlet hose to a water tap
with an external thread of 3/4".
Warning! Make sure that the retaining nut and all
other connections are tight before you move the
dishwasher into position.
Warning! Always use a new water inlet hose. Do not
use connection hoses from an old appliance.
Drain hose
The appliance has water safety system to prevent
water damage. If there is a malfunction, the drain
14
door does not catch on the sides of the cabinet. If the door
does not close correctly, loosen or tighten the adjustable
feet until the appliance is level.
pump automatically starts to drain the remaining water out
of the dishwasher.
when the dishwasher is off.
Two procedures are possible to install the water drain
hose :
1. Attach the plastic curve supplied at the end of the
1. Loosen the
retaining
2. Connect the water drain hose to the water drain sys-
nut.
2. Turn the
hose.
3. Tighten the
retaining
nut.
Warning! Only if the dishwasher is connected to the
mains socket, the water safety system operates
1
2
max. 75cm
hose.
Put the water drain hose in the sink.
tem.
The hose must be less than 75 cm above the bottom
of the dishwasher to prevent incorrect operation of
appliance.
If you connect the water
drain hose to a trap spigot
under the sink, remove the
plastic membrane (A). If
you do not remove the
membrane, remaining food
can cause a blockage in the
drain hose spigot