Fuel Guide Operating Controls And Features; Operating Controls And Features - Toyotomi RS-W30 Additional Installation, Operation And Maintenance Instructions

ASSEMBLY AND OPERATION ASSE
INSPECTION AND ASSEMBLY INSPECTION AN
NOTE: Please save the shipping carton and packing materials for future storage of your heater. NOTE: Please save the shipp
1. REMOVE PACKING MATERIALS 1. REMOVE PACKING MATE
Open the grille by raising the lower right hand corner of grille and pulling straight out. Slide the cardboard Open the grille by raisin
packing down by spreading out to release the heat chamber assembly. Lift the heat chamber, in its protective packing down by spread
packing, out of the cabinet. packing, out of the cabine
2. REPLACE THE HEAT CHAMBER 2. REPLACE THE HEAT CHA
Remove the cardboard packing, and replace the heat chamber assembly. Point the wire handle to the front of the Remove the cardboard pa
heater. heater.
Close the grille. Close the grille.
3. INSTALL THE BATTERIES 3. INSTALL THE BATTERIES
Locate the battery holder on the back of your heater. Locate the battery holder
Insert the battery 4 "C" size batteries according to the plus (+) and minus (–) Insert the battery 4 "C
● ●
markings. markings.
4. CHECK THE HEAT CHAMBER 4. CHECK THE HEAT CHAM
If the chamber is raised, put it down and inlay it. If the chamber is raised, p
NOTE: If the heat chamber is raised, it can cause smoke and soot. NOTE: If the heat chamber is
FUELING FUELING
WARNING: Use only clean kerosene (paraffin). WARNING: Use only cle
NEVER use gasoline (petrol) or other flammable liquids. NEVER use gasoline (petr
4