Table of Contents
Advertisement
The wick height adjuster knob, with three small holes marked 1, 2, and 3, can be
The wick height adjuster kno
seen. The stem pin is engaged in one of the holes. Pull the control dial toward you
seen. The stem pin is engag
and change the location of the pin from 1 to 2, or from 2 to 3. Each step from
and change the location of
pin 1 to 2 will raise the maximum wick height by 2 mm per step. After this
pin 1 to 2 will raise the
adjustment, replace the wick adjuster knob.
adjustment, replace the wick
When suitable flame length can no longer be achieved even on pin position 3, it is
When suitable flame length
time to clean and replace the wick. AFTER REPLACING THE WICK, CHECK THE
time to clean and replace t
OPERATION OF THE AUTOMATIC EXTINGUISHER BEFORE LIGHTING YOUR
OPERATION OF THE AUT
HEATER.
HEATER.
NOTE: NEVER use positions 2 or 3 until position 1 no longer gives adequate
NOTE: NEVER use position
flame length.
flame length.
EXTINGUISHING THE FLAME
EXTINGUISHIN
1. Turn the wick adjuster knob counterclockwise until it stops. This requires about a
1. Turn the wick adjuster kno
half turn. At this point, the flame is completely extinguished and the heater is off.
half turn. At this point, the
NOTE: DO NOT use the automatic extinguisher to routinely turn off the heater.
NOTE: DO NOT use the a
Automatic extinguishing should occur only when the heater is jarred or
Automatic extinguis
tipped. Using the automatic extinguisher to turn off the heater will cause
tipped. Using the a
odor, smoke and soot.
odor, smoke and soo
2. Make sure the flame is out completely.
2. Make sure the flame is ou
3. DO NOT try to relight the heater for at least three (3) minutes after extinguishing it
3. DO NOT try to relight the
off as this may cause smoke and odor.
off as this may cause smo
MANUAL SHUTOFF
MANUAL SHOTOFF
MANUAL SHO
When quick shutoff is necessary, push the manual shutoff button.
When quick shutoff is neces
NOTE: For routine turn-off, DO NOT use the Manual Shutoff or activate the
NOTE: For routine turn-of
Automatic Extinguisher by jarring the heater. These methods may cause
Automatic Extinguis
unwanted odor, soot and smoke. Only the wick adjuster knob should be
unwanted odor, soo
used for normal shotoff.
used for normal shutoff.
used for normal shot
8
Wick hight
adjuster knob
Stem pin
Advertisement
Table of Contents
