Table of Contents
Advertisement
ADJUSTING THE FLAME
1. After lighting, wait for the heat chamber to reach operating temperature. This will take several minutes, then the
flame will be visible.
2. CHECK THE FLAME HEIGHT
After five minutes, the entire heat chamber should be glowing red.
TOO HIGH
Produces smoke
and soot
If necessary, raise or lower the wick by turning the wick adjuster knob to produce the proper flame condition.
NOTE: DO NOT operate your heater wick set TOO LOW or TOO HIGH. Doing so will decrease combustion effciency
and increase production of unwanted emissions. When operating heater, be sure wick is high enough to
keep the primary heat chamber heated to a uniform red glow from its top bottom.
3. ADJUSTMENT OF MAXIMUM WICK HEIGHT.
After using the heater over a long period of time, you may observe that flame length in the heat chamber does
not reach its normal level several minutes after lighting. When this condition is observed, it means that the wick
not reach its normal level several minutes after lighting. When this conditin is observed, it means that the wick
height needs adjusting using the unique wick life extender.
To adjust the wick height using the wick life extender mechanism, first release the
automatic extinguisher by pushing the manual shutoff button.
Pull the wick adjuster knob out completely. (It can be removed completely from
its shaft.)
BAD
GOOD
Maximum
Efficient combustion
GOOD
Minimum
CORRECT
7
BAD
TOO LOW
Produces odor
he
cy
to
es
ck
Advertisement
Table of Contents
