Table of Contents
Advertisement
INSTALLATION
•
Remove all packing material before using your appliance.
•
IMPORTANT: Before connecting the unit to a power source, let it stand upright for
approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
•
Clean the interior surface with lukewarm water and a soft cloth.
•
This unit is designed for freestanding or built in installation for indoor or outdoor use .
Position the unit in a dry and well-ventilated place. Avoid placing the unit near any source of
heat or moisture, or in direct sunlight. Do NOT install the unit in a location with an ambient
temperature that will fall below 44°F.
•
For freestanding installation, 5 inches of space between the back and sides of the unit are
suggested, which allows the proper air circulation to cool the compressor and condenser for
energy saving. Even for built-in installation, it is a must to keep ¼" space on each side and
at the top to ensure proper service access and ventilation. And the air vent at the front of
the appliance must never be covered or blocked in any way.
•
Place the unit on a level surface strong enough to support it when it is fully loaded. To level
the appliance, adjust the front
•
For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 44 ° -
recommended temperatures, the performance of the unit may be affected.
adjustable feet
at the bottom of the appliance.
°F. If the ambient temperature is above or below
100
(The picture is just for reference)
9
Advertisement
Table of Contents
