Table of Contents
Advertisement
Item
Condition
5. DQT
1) CH : TX low (Wide)
balance
CH : TC center (Wide/Narrow)
CH : TX high (Wide)
2) Transmit
6. MAX
1) CH : TX low (Wide)
balance
CH : TC center (Wide/Narrow)
CH : TX high (Wide)
2) AG : 1kHz/50mV
3) Transmit
7. MIC
1) CH : TX center (Wide/Narrow)
sensitivity 2) AG : 1kHz/5mV
3) Transmit
8. DQT
1) CH : TX low (Wide)
deviation
CH : TX center (Wide/Narrow)
CH : TX high (Wide)
2) Transmit
9. QT
1) CH : TX low (Wide)
deviation
CH : TX center (Wide/Narrow)
CH : TX high (Wide)
2) Transmit
10. DTMF
1) CH : TX center (Wide/Narrow)
/MSK
2) Transmit
deviation
If normal power is not obtained, please follow the
step below
Open the shielding cover (upper), and screw 3 locations
around ANT pin.
1. Switch off the transceiver.
Impedance of Final FET (Q504) and Drive FET (Q503) can
be measured easily using DVM Ω mode.
Normal condition – Gate : 20kΩ~50kΩ, Drain : 1MΩ~2MΩ
The above impedance values are rough estimations.
2. Switch on the transceiver. Check the voltage at R823 out-
put point.
The voltage is around 13.6V in receiving condition. The
voltage will be 12.6V~ in transmitting condition.
3. Remove R525.
ADJUSTMENT
Measurement
Test equipment
Terminal
Modulation analyzer ANT
or Linear detector
(LPF : 3kHz)
Oscilloscope
Modulation analyzer ANT
or Linear detector
MIC
(LPF : 15kHz)
Oscilloscope
AG
AF V.M
Modulation analyzer
or Linear detector
(LPF : 3kHz)
Oscilloscope
4. Connect 50Ω load at the ANT location.
Transmit and check current drain at High power mode.
If the current drain is less than 1A, then Final FET is bro-
ken.
If the current drain is less than 5.0A, short the Drive FET
gate to ground, and check the current drain.
If the current drain is not 0.1A less than the original value,
then the Drive FET is broken.
5. Check input power level at Drive FET gate location.
Connect the wire to [RF] location.
Transmit and check for power to be within the range of
0.7W~1W.
If power found is less than 0.5W, check the circuit before
the Drive FET.
TK-8108H
Adjustment
Parts
Method
PC key
Adjust the waveform as below
± 4.0kHz (Wide)
± 2.0kHz (Narrow)
According to the large +, –
Check
± 0.75kHz (Wide)
± 0.35kHz (Narrow)
± 0.75kHz (Wide)
± 0.35kHz (Narrow)
± 3.0kHz (Wide)
± 1.5kHz (Narrow)
Specifications/
Remarks
± 50Hz
± 3kHz± 0.2kHz
(Wide)
± 1.5kHz± 0.1kHz
(Narrow)
± 0.05kHz
± 0.05kHz
± 0.2kHz
33
Advertisement
Table of Contents
