Table of Contents
Advertisement
PARTS LIST - SECTION F
Qty.
Description
1
Button (red)
3
Sleeve Input Socket (yellow)
1
Sleeve Input Socket (red)
1
Case Top
1
Case Bottom
1
Cover Battery
2
Screw LCD Housing 2.5 x 8mm
Note: The shield may be installed already.
FINAL ASSEMBLY
Solder the spring to the PC board as shown in
Figure Q.
Install the bottom two 2.5 x 8mm screws to the
LCD housing as shown in Figure R.
Peel off the protective backing on the top label
(A) and bottom label (B) and stick them to the top
case as shown in Figure S.
Place the PC board into the bottom case. Feed
the battery clip through the case as shown in
Figure T.
Place the four colored sleeves over the input
sockets as shown in Figure T. Note that the black
sleeve goes on the COM socket.
2.5 x 8mm Screws
Figure R
SECTION F
Final Assembly
Part #
Qty.
622027
2
622660
1
622661
1
623112
1
623203
1
623210
1
642239
1
Place the red power cap onto the switch SW1 as
shown in Figure T.
Solder
Bottom Label (B)
-22-
Description
Screw Case 3 x 17.5mm
Spring
Label Bottom
Shield Label
Holster
Test Leads Alligator
Test Leads Red-Black
Spring
Figure Q
Figure S
Part #
642240
680033
723052
780012
9C72
9TL13
9TL14
Top Label (A)
Advertisement
Table of Contents
