Table of Contents
Advertisement
ASSEMBLE THE FOLLOWING COMPONENTS TO THE PC BOARD
In all of the following steps the components must be installed either on the top or bottom legend sides of
the PC board as indicated. The board is turned to solder the component leads on the opposite side
(installed on Bottom, soldered on Top, installed on Top, soldered on Bottom).
Figure H
Stand diode on end. Mount with band as
shown on the top legend.
Band
D1 - 1N4001 Diode
D2 - 1N4001 Diode
(see Figure H)
R19 - 900
.5% 1/4W Res.
(white-blk-blk-blk-green)
(see Figure I)
R20 - 90
.5% 1/4W Res.
(white-blk-blk-gold-green)
(see Figure I)
R21 - 9
.5% 1/4W Res.
(white-blk-blk-silver-green)
(see Figure I)
R22 - 0.99 .5% 1/4W Res.
(blk-wht-wht-silver-green)
(see Figure I)
R33 - 5.6k
5% 1/4W Res.
(green-blue-red-gold)
(see Figure I)
R30 - 13k
1% 1/4W Res.
(brn-orange-blk-red-brn)
(see Figure I)
R31 - 900
1% 1/4W Res.
(white-blk-blk-blk-brown)
(see Figure I)
VR1 - 200
Pot
(201)
R32 - 390
1% 1/4W Res.
(orange-wht-blk-blk-brown)
(see Figure I)
Figure I
White marking
on PC board
Stand resistor on end as shown.
Solder and cut off the excess leads.
Top Legend Side
See Page 21 for Assembled View
Bottom Legend Side
-14-
R15 - 90k
.5% 1/4W Res.
(white-blk-blk-red-green)
(see Figure I)
R14 - 900k .5% 1/4W Res.
(white-blk-blk-orange-green)
(see Figure I)
R10 - 2.25M .5% 1/4W Res.
R11 - 2.25M .5% 1/4W Res.
R12 - 2.25M .5% 1/4W Res.
R13 - 2.25M .5% 1/4W Res.
(red-red-green-yellow-green)
(see Figure I)
R18 - 100
.5% 1/4W Res.
(brown-blk-blk-blk-green)
(see Figure I)
R17 - 900
.5% 1/4W Res.
(white-blk-blk-blk-green)
(see Figure I)
T2 - 9013 Transistor
(see Figure C)
R16 - 9k
.5% 1/4W Res.
(white-blk-blk-brown-green)
(see Figure I)
R23 - Shunt Wire
1/4"
PC Board
Fuse Holder Clips
Fuse 0.2A 250V
Mount holders with the tab
side as shown on the bottom
legend side, solder into place
and then insert fuse.
Tab
Tab
Advertisement
Table of Contents
