Omron HN-290T Instruction Manual page 15

6. Error Messages and Troubleshooting
6.2 Troubleshooting
Problem
Even if you step onto
the unit, nothing is
displayed.
Connecting failure.
The data is not
being transmitted.
* To retry connecting the Telehealth service receiver, remove batteries and insert
them again. Then start with section 2.4 again.
Cause
No batteries are inserted. Insert the batteries.
The batteries are inserted
in the wrong direction.
The batteries are worn
out.
The receiving device is
too far away from the
device.
The application on the
receiver or destination
device is not ready.
15
Correction
Insert the batteries in the
correct direction.
Replace all four batteries
with new ones.
After checking that
there are no sources of
interference nearby, move
the receiving device to a
distance within 5 m (16 ft.)
of the scale. Then try to
connect again*.
Check the application then
try to connect again*. If the
"Err" is on the screen after
checking the application,
contact your Telehealth
service provider.