Table of Contents
Advertisement
5. FILTER CARTRIDGE REPLACEMENT
NOTE:
The life of the filter cartridges depends on water volume filtered and the quality of the feed water. It is recommended that
the filter cartridges be replaced every regularly, or when there is noticeable change in taste, odour, or flow of filtered water.
Ensure the correct replacement cartridge model (Refer to cartridge part number on the cartridge label) are purchased
for the system
5.1 Cartridge Replacement
A.
Relieve pressure by turning off the water supply to
the system and opening a faucet until water flow
stops. Place a bucket or towel under the system to
catch any water drips (Figure 5.1a).
B.
Remove the cover and lift the locking bar upward
until the filter cartridge disengages from the filter
head assembly (Figure 5.1b).
C.
Pull the cartridge away from the filter head assembly
(Figure 5.1c).
D.
Ensure the locking bar is fully in the up position
(Figure 5.1c).
E.
Align the posts on the filter cartridge with the ports in
the filter head assembly. Slide the cartridge filter
towards into the filter head assembly engaging with
the locking bar, causing it to drop forward and down
(Figure 5.1d).
F.
Pull down the locking bar until it snaps into place
(Figure 5.1e)
G.
Install cover.
NOTE:
See section 4.3 - 9, Placing the System into
Operation section for remaining steps.
5.1b
10 • EVERPURE F2100 & F2200 User's Manual
5.1c
5.1a
NOTE:
Actual faucet may vary from image.
5.1d
5.1e
Advertisement
Table of Contents
