Previewing The Alarm And Turning The Alarm On/O - iHome iWBT400 Instruction Manual

Setting and Using the Alarms
1. Press and hold the Alarm Button for 2 seconds until the alarm time display and alarm icon
flash. A beep sounds.
2. Press the or
setting). Make sure you set the correct AM/PM alarm time. The AM and PM indicators
appear to the left of the display.
3. Press the Alarm Button to confirm the alarm time setting. The alarm schedule will flash.
4. Press the or
(week days) or 2 days (weekends).
5. Press the Alarm Button to confirm the alarm schedule setting. The wake-to source will
flash.
6. Press the or
tones.
Wake to Bluetooth: You will wake to the currently linked Bluetooth device. If no device is
detected, the alarm will default to tone alarm.
Wake to Radio: Press the Alarm Button to confirm. Press the Presets Button to select an
FM preset to wake to, or press the
set Presets, see Setting and Using FM Presets on page 10.)
Wake to Tone: You will wake to one of 4 tones. Press the Alarm Button to confirm. Press the
or Buttons to cycle through and hear tones 1 -4.
7. Press the Alarm Button to confirm the alarm settings and exit alarm setting mode. 2 beeps
will confirm alarm setting is complete. The alarm icon will remain on the display, indicating
the alarm is armed.
8. To turn o a sounding alarm and reset it to come on the next day at the same time, press
Power/Alarm Reset Button or the associated alarm button (
the

Previewing the Alarm and Turning the Alarm On/O

Press and release the desired Alarm Button as needed to toggle the alarm ON (indicated by the
alarm icon) or OFF (no alarm icon).
Buttons to adjust the alarm time to the desired time (hold for rapid
Buttons to cycle to the desired schedule: 7 days (every day), 5 days
Buttons to select the desired wake to alarm source: Bluetooth, radio or
(Continued)
Buttons to tune in a desired wake to station. (To
or
8
iWBT400
Using the
or ) to reset alarm.