Table of Contents
Advertisement
End of the programme
End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
Start/Pause button to start the final
drain/spin cycle.
Notes
The programme continues by
■
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
If only the water is to be pumped out,
■
approx. 1 minute after the
programme starts, touch the Start/
Pause button before the spin cycle
starts. The programme is interrupted
and the door lock is released. The
laundry can be removed.
If Hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
Wrinkle guard process starts after
■
drying process is finished to prevent
laundry getting wrinkle if you do not
take laundry out in time. The process
lasts about 30 minutes. 0:00 will be
displayed in time display and V
symbol will be displayed as the
status symbol. You can press any
button or rotate the programme
selector to another position to
terminate this process, then the door
will be released and laundry can be
taken out.
Operating the appliance
Removing laundry/switching
off the appliance
Set programme selector to Off.
1.
Open the door and remove the
2.
laundry.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Wipe the rubber seal dry.
■
Leave the door and detergent
■
drawer open so that any residual
water can evaporate.
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
en
39
Advertisement
Table of Contents
