Changing The Programme; Cancel The Programme; Programme End; Removing Laundry/Switching Off The Appliance - Bosch WDU8H540SN Instruction Manual

Operating the appliance
en
If the following appears on the Touch-
Display:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
A button. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the A button.
1.
Select another programme.
2.
And touch the A button again. The
3.
new programme starts from the
beginning.
If drying is activated, you have to
Note:
switch the appliance off and on again to
change the drying programme.

Cancel the programme

For programmes washing at high
temperatures:
Touch the A button.
1.
To cool down laundry: Select Rinse.
2.
Touch the A button.
3.
For programmes washing at low
temperatures:
Touch the A button.
1.
Select Spin.
2.
Touch the A button.
3.
40
For programmes in drying process:
Switch the appliance off.
1.
Switch the appliance on again.
2.
To cool down laundry: Select the My
3.
Time + Dry.
Touch the A button.
4.

Programme end

End lights up on the Touch-Display and
A and Õ displays are off.
If you have selected 2, the water is only
drained after rinse process, no spin
cycle.
Notes
If Hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
Wrinkle guard process starts after
■
drying process is finished to prevent
laundry getting wrinkle if you do not
take laundry out in time. The process
lasts about 30 minutes. ˜—à•, £©,
and "Ÿš will be displayed alternately
on Touch-Display and Q symbol will
be displayed as the status symbol.
You can touch any area of Touch-
Display to terminate this process,
then the door will be released and
laundry can be taken out.
Removing laundry/switching
off the appliance
Press the # button till the indicator
1.
lamp turns off, release the button.
The appliance is switched off.
Open the door and remove the
2.
laundry.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.