Table of Contents
Advertisement
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if
Note:
necessary.
Insert all four sleeves.
2.
a) Clip the mains cable securely in
the holders.
Positioning and connecting
b) Insert and tighten the screws.
c) Clip the hoses securely in the
holders.
Before switching on the appliance
again:
Notes
The support struts must be
■
removed.
~ "Removing the support struts"
on page 15
The transport braces must be
■
removed.
~ "Removing the transport locks"
on page 14
Pour approx. 1 litre of water into
■
dispenser II, select the Spin
programme and start.
This will prevent detergent from
flowing straight into the drain during
the next wash.
en
21
Advertisement
Table of Contents
