Glass Specifications; Electrical Rating (On High); Mobile Home Approved; Sleeping Room - Hearth and Home Technologies Quadra-Fire PS35-C Owner's Manual Operation & Care

Pellet burning stoves
Table of Contents

Advertisement

D. Glass Specifications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please
contact your dealer for replacement glass.
E. Electrical Rating (on high)
115 VAC, 60 Hz, Start 3.8 Amps, Run 1.3 Amp
F. Mobile Home Approved
This appliance is approved for mobile home
installations when not installed in a sleeping room and
when an outside combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling,
and walls must be maintained.
The appliance must be properly grounded to the frame
of the mobile home with #8 copper ground wire, and
use only listed double-wall connector pipe.
Outside Air Kit, part 811-0872 or OAK-3 must be
installed in a mobile home installation.
Appliance must be secured to mobile home structure.
G. Sleeping Room
When installed in a sleeping room it is recommended that
3ft of vertical be installed prior to horizontally exiting the
room and a smoke/CO alarm be installed in the bedroom;
The size of the room must be at least 50ft³ per 1,000 Btu/hr
stove input, if the stove exceeds the room size, outside air
must be installed.
H. California - Prop65
WARNING
This product and the fuels used to operate this product (wood), and
the products of combustion of such fuels, can expose you to
chemicals including carbon black, which is known to the State of
California to cause cancer, and carbon monoxide, which is known to
the State of California to cause birth defects or other reproductive
harm. For more information go to: WWW.P65Warnings.ca.gov
8
Fire Risk
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
Installation and use of any damaged appliance.
Modification of the appliance.
Installation other than as instructed by Hearth &
Home Technologies.
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Operating appliance without fully assembling
all components.
Operating appliance without legs attached (if
supplied with appliance).
Do NOT Over fire - If appliance or chimney connector
glows, you are over firing.
Any such action that may cause a fire hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer
of this appliance, reserves the right to alter
its products, their specifications and/or price
without notice.
Hearth & Home Technologies WILL NOT warranty
appliances that exhibit evidence of over-firing. Evidence
of over-firing includes, but is not limited to:
Warped air tube
Deteriorated refractory brick retainers
Deteriorated baffle and other interior components
7058-805F
WARNING
04/21

Advertisement

Table of Contents
loading

Table of Contents