Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card connector.
2. Slide the solid-state drive into the M.2 card connector on the system board.
3. Replace the single (M1.6x2.5) screw that secures the solid-state drive to the system board.
4. Align and place the solid-state drive shielding cover, press to fit it firmly to cover the solid-state drive.
Next steps
1. Install the
base
cover.
2. Install the
SIM card
tray.
3. Install the
SD
card.
4. Exit
service
mode.
5. Follow the procedure in
Wireless Wide Area Network (WWAN) Card
Removing the WWAN card
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
22
Removing and installing components
After working on your
computer.
before working inside your
computer.